Elvie Stride 2 - Page 13

13
4.5 Assembling Elvie Stride 2
Wash hands thoroughly before you begin. Once the parts have been cleaned and
disinfected, make sure they are dry and not moldy before putting them together.
Pay extra attention to the Diaphragm and Stopper, ensure it is completely dry.
1. Push the Hub Connector firmly into the
Hub, ensuring that it is fullyinserted.
2. Push the Valve into the Cup Front.
3. Push the Diaphragm with Stopper onto
the Cup Front then close thestopper.
4. Use your fingers to work the Diaphragm rim over the Cup Front lip.
Take a moment to check the Diaphragm is sitting flush and on securely.
5. Fit the Breast Shield over the Cup Front. Ensure it’s sealed tightly all the way
around and there are no gaps. The Cup Front should be fully covered by the
lip of the Breast Shield. You can use a Nipple Insert here if needed.
6. Check that the Diaphragm is completely dry as moisture can be sucked into
the Hub. This aects the performance of your pump.
7. Push the Cap over the Diaphragm onto the Cup Front, ensuring that
the tube is aligned with either the left or the right channel.
8. Attach the Hub to your clothing using the clip.