Elvie Stride 2 - Page 14

14
4.6 Single-side pumping
with ElvieStride2(Double)
To pump on one side with Elvie Stride 2
(Double), you only need one Short Tube
that connects to one Cup. Remove the
unused Short Tube from the Tube Splitter.
Seal the opening with the Tube Splitter
Stopper to ensure consistent suction
on the one Cup in use.
Tip: Make sure the Tubes are not kinked
or pinched flat
5. Using Elvie Stride 2
5.1 Turning on Elvie Stride 2
Once fully assembled, press Power to turn the Hub on. The intensity lights
will begin to flash and will show the intensity setting that stimulation mode
will start on. You can adjust the intensity setting before you start yoursession.
5.2 Aligning your nipple
All nipples are dierent and change throughout your pumping journey.
We recommend resizing regularly for the best fit.
To ensure a comfortable and ecient pump you’ll need to correctly
align your nipples with the Nipple Insert/Breast Shield. Follow the
direction of your nipples when putting the Breast Shieldon.
To avoid discomfort, your nipple must also be positioned correctly
in the Nipple Tunnel before pumping. To do this:
1. Align your nipple to the centre of the assembled Cup, making sure that your nipple
isn’t touching the side of the tunnel and that the tip isn’t obstructed.
Breast Shield correctly aligned
Breast Shield incorrectly aligned
2. Bend over forwards whilst supporting your breast underneath with your hand.
Bring the Cup to your breast, paying attention to the direction of your nipple.