Elvox RS04 - Remote Control Management (RAD)

30
6- After closing M1 the display shows LOC (operates the electric lock)
7- M1 starts to open at slow speed and continues until the mechanical stop, the display will show OPN1
8- M2 starts to open at slow speed and continues until the mechanical stop, the display will show OPN2
9- M2 starts to close at cycle speed and then slows down and continues until the mechanical stop, the display will show CLS2
10- M1 starts to close at cycle speed and then slows down and continues until the mechanical stop, the display will show CLS1
11- The control panel runs a full gate leaf opening and closing cycle to save the current thresholds, the display will show 4 dots
12- After closing, the display will show END, the procedure has been successfully completed.
The reduced procedure allows saving the travel, with distances for slowing down of 30% the total travel, while the gate leaf delays are xed at 3 sec-
onds for opening and 6 seconds for closing.
N.B.: If the direction of gate leaf movement is incorrect, press the ESC button, the control panel will exit programming and block gate movement.
Modify the electrical wiring harness of the gearmotors and repeat the procedure.
7.2 RAD: remote control management menu is divided into 4 parameters:
Description of RAD menu parameters:
Display
Message
Description Display message after activating the remote control
1 CH Used to save the remote control button corresponding to the input AP/CH 1***
2 CH
Used to save the remote control button corresponding to the input PED or output
2CAN
2***
CTRL
Pressing the button on the remote control lets you compare and see where the
memory cell has been saved.
1*** or 2***
ERAS
Used to delete a remote control in the memory list or all the remote controls in
the memory.
After selecting the remote control from the list press OK and the
display will show OOOO to confirm deletion. To delete all the
remote controls select ALL between 200 and 001 and press OK,
the display will show 0000
Premendo
1 volta UP
Premendo
2 volte UP
Premendo
3 volte UP
Press the
UP button
3 times
Press the
UP button
2 times
Press the
UP button
1 time
EN