Elvox RS04 - Adjusting Automatic Closing Time; Programming Menu Details

29
VIMAR group
6.3 Example of the procedure for changing the automatic closing time:
3
1- Press the UP button 4 times, the display will show PAR (parameters)
2- Press OK, the display will show P01
3- Press the UP button once, the display will show P02 (automatic closing time)
4- Press the OK button, the display will show the automatic closing time
5- With the DOWN or UP button you can vary the automatic closing time
6- Press the OK button to conrm and save the modied value
7- Full description of the programming menu.
The programming menu is divided into 3 levels: first the main level, second the parameters level and third the values level
Main menu:
Display Message Description
LRNE Travel learning with rapid programming (see paragraph 6), function only available for motors operating with an encoder
RAD Remote control management
LRN Learning travel with custom programming
PAR Used to modify all the parameters of the control panel
DEF Used to go back to the default values
CNT Used to view the manoeuvres carried out
ERR Used to view a list of the last 9 errors or malfunctions
PASS Control panel protection level setting
After selecting the desired item from the main menu by pressing the UP or DOWN button, conrm by pressing OK.
7.1 LRNE: quick procedure for programming gate leaf travel
It requires motors operating with an encoder and mechanical stops both when opening and closing and during programming and dur-
ing normal operation.
1- Press the UP button once, the display will show LRNE
2- Conrm with the OK button, the display will show APCH
3- Press the APCH button
4- The display reads CLS2, motor M2 closes until the mechanical stop
5- After closing M2, M1 starts to close and the display shows CLS1
1 2 4 5
6
1 2 3 4 5
6 7 8 9 10
11 12
x4
EN