EMAK EF 95 - Troubleshooting Error Codes; Error Code Identification and Reset Procedures

67
GB
DISPLAY PROBLEM POSSIBLE CAUSES SOLUTION
Err 02 Brake switch ECU detects invalid status of the
brake switch
1. Switch the ignition off
and back on (position 2)
2. Caricare e scaricare più
volte il sedile
*
Err 03 Mower
mechanism
switch
ECU detects invalid status of the
mower mechanism switch
1. Switch the ignition off
and back on (position 2)
2. Operate mower
mechanism switch
several times
*
Err 04 Box switch ECU detects invalid status of the
box switch
1. Switch the ignition off
and back on (position 2)
2. Open and close box
several times
*
Err 05 Transmission
switch
ECU detects invalid status of the
transmission switch
1. Switch the ignition off
and back on (position 2)
2. Operate reverse pedal
several times
*
Err 06 Discharge
channel switch
ECU detects invalid status of the
discharge channel switch
1. Switch the ignition off
and back on (position 2)
2. Remove and reinstall
discharge channel
*
Err 07 Mower
mechanism
ECU detects incorrect status of
the mower mechanism output
Switch the ignition off and
back on (position 1)
*
Err 08 Start relay ECU detects incorrect status of
the start relay output
Switch the ignition off and
back on (position 1)
*
Err 09 Solenoid valve
engine
ECU detects incorrect status of
the engine solenoid valve
output
Switch the ignition off and
back on (position 1)
*
Err 10 Ignition coil ECU detects incorrect status of
the ignition coil output
Switch the ignition off and
back on (position 1)
*
Err 11 Internal supply
voltage
ECU detects incorrect status of
the internal supply voltage
output
Switch the ignition off and
back on (position 1)
*
Err 12 Internal supply
voltage
monitoring
ECU detects incorrect status of
the internal supply voltage
monitoring
Switch the ignition off and
back on (position 1)
*
* Self-diagnosis, possible automatic fault deletion; the display goes out for about 4 seconds in
this case.
Or contact service