BATTERY
To ensure long life to the battery it is essential to keep it carefully maintained.
The battery on your machine must be charged before using for the first time
and, subsequently, if the machine is stored, before the next time of starting up.
– Carefully read and comply with the procedure for recharging described in the
booklet coming with the battery. If the procedure is not followed or the battery
is not charged, irreparable damage could be caused to the elements inside the
battery.
– A flat battery must be recharged as soon as possible.
Recharging must be done using a battery charger at con-
stant voltage. Other recharging systems can irreversibly damage the battery.
The machine has a connector (1) for
recharging, to be connected to the corre-
sponding connector of the special “CB01”
maintenance battery-charger supplied
( if included) or available on request
(chapter 8).
This connector must
only be used for connection to the
“CB01” maintenance battery-charger. For its use:
– follow the instructions given in the relative instruction booklet,
– follow the instructions given in the battery booklet.
E
LECTRICAL SYSTEM
The electronic card and the electrical
system are protected by:
– a self-resetting device which breaks the
circuit when there is a function fault, and
is accompanied by an audible signal
which continues until the key is remo-
IMPORTANT
➤
IMPORTANT
ENG 31MAINTENANCE
To Next Page
Loading...
Need help?
General
