1. Warning: Read the Operator’s Manual
before operating this machine.
2a. Warning: in the electric start
models: remove the key and read the instruc-
tions before carrying out any maintenance or
repairs.
2b.
Warning: in the manual start
models: disconnect the spark plug cap and
read the instructions before carrying out
any maintenance or repairs.
3. Danger! Ejected objects: Do not operate
without the grass-catcher in place.
4. Danger! Ejected objects: Keep bystan-
ders away.
5. Danger! Machine rollover: Do not use
this machine on slopes greater then 10°.
6. Danger! Dismemberment: Make sure that children stay clear of the machine all the time
when engine is running.
7. Danger of cutting yourself. Blade in movement. Do not put hands or feet near or under
the opening of the cutting plate.
➤
➤
1.3 SAFETY LABELS
Your machine must be used with care. Therefore, labels have been placed on the
machine to remind you pictorially of the main precautions to take during use.
These labels are to be considered an integral part of the machine.
If a label should fall off or become illegible, contact your Retailer to replace it.
Their meaning is explained below.
EN 5SAFETY
before restarting and operating the equipment;
– If the machine starts to vibrate abnormally
(inspect it immediately).
11) Disengage the blade when transporting or
whenever it is not in use.
12) Stop the engine and disengage the blade:
– before refuelling;
– before removing the grass-catcher.
13) Reduce the throttle setting before stopping
the engine.
D) MAINTENANCE AND STORAGE
1) Keep all nuts, bolts and screws tight to be
sure the equipment is in safe working condi-
tion.
2) Never store the machine with petrol in the
tank inside a building where fumes may reach
an open flame or spark.
3) Allow the engine to cool down before stor-
ing in any enclosure.
4) To reduce the fire hazard, keep the engine,
silencer, battery compartment and petrol stor-
age area free of grass, leaves, or excessive
grease.
5) Check the grass-catcher frequently for wear
or deterioration.
6) Replace worn or damaged parts for safety.
7) If the fuel tank has to be drained, this
should be done outdoors.
8) When the machine is to be stored or left
unattended, lower the cutting deck.
1 4
2a 5
2b 6
3 7
To Next Page
Loading...
Need help?
General
