6.5 Reprogramming Tinyhawk Flight Controller
1.
Put the Flight Controller in DFU mode by pressing the BOOT button while plugging in
the micro USB cable to a computer.
2.
Select STM32F411 as the target and then select the firmware . Select Manual Baud Rate
with 256000 in the drop down menu
3.
Select Load Firmware(Online) to download the firmware
4.Select Flash Firmware to program the flight controller
6.6 Set the Correct Settings
Download the latest CLI Dump File from https://emax-usa.com/
Connect Tinyhawk to Betaflight configurator and select the CLI tab
Open the CLI Dump File in a text editor and copy all the text.
Paste the settings into the command bar and press enter
Tinyhawk III will reconnect to Betaflight when completed
7. How To Fly Tinyhawk III
Before turning on the drone, please learn the controls first, and then turn on the drone. Be
cautious when flying and operate in an open and controllable area.
(Take EMAX's E8 Transmitter and Transporter 2 Goggles as examples)
First turn on the power of E8 Transmitter and Transporter 2. Tinyhawk III has been bound to
E8 Transmitter and matched with your Transporter 2 on the correct video channel. Turn on
your Tinyhawk III by sliding the battery into the battery tray and plugging in the power
source. After the battery is inserted, place the Tinyhawk III on a level and stable surface so
that it can be calibrated.
To Next Page
Loading...
Need help?
General
