Need help?Do you have a question about the Emax Nighthawk Pro and is the answer not in the manual?
General| Brand | Emax |
|---|---|
| Model | Nighthawk Pro |
| Category | Quadcopters |
| Language | English |
Prepare the Nighthawk Pro frame by placing it on a horizontal plane.
Install necessary drivers and the Baseflight Configurator software.
Connect the receiver to the flight controller, specifically for the ARF model.
Guide on using Baseflight Configurator for flight controller setup.
Calibrate the accelerometer and magnetometer for accurate flight.
Calibrate the Electronic Speed Controllers (ESCs) for proper motor response.
Install components like velcro, receiver, antennas, and propellers.
Procedure for powering on the copter, arming motors, and initial flight checks.
Instructions for installing optional upgrade accessories.
Detailed procedure for calibrating the ESCs, including single ESC calibration.
Instructions for connecting and configuring the buzzer for low voltage warnings.
How to enable and connect battery inspection for voltage monitoring.
Explanation of the LED indicators during the self-checking process.
Steps to enter bootloader mode for firmware updates on the control board.
To Next Page
