Nighthawk Pro
www.emaxmodel.com
３
controller, to satisfy the constant update and upgrade with FPV enthusiasts' need.
Please read the instruction manual and warnings carefully, make sure battery charged and power connections are
good during flights. Do NOT fly around crowds, children, animals or objects. Emax accepts no liability for damage(s) or
injuries incurred directly or indirectly from the use of this product.
Warnings
1、Please following the instruction manual to install and operate Nighthawk Pro
2、Do NOT use Nighthawk Pro while drunk, taking drugs, dizziness, fatigues, nausea and any other conditions no matter
physically or mentally that could impair your ability.
3、Must fly in safe zone (Area larger than 2500 square meter)
4、Do NOT modify or overload the system with inappropriate parts or accessories.
5、Do NOT fly at severe weather conditions (Such as wind speeds exceeding 10m/s, snow, rain, thunder and fog)
6、Do NOT fly in high-electromagnetic environment.
Certifications
Nighthawk have certified by CE, FCC, RoHs.
Features Highlight
1．Independent designed solid, durable and stable frame, centroid and center of gravity are nearly the same even battery
installed
2
． Prebuilt frame and extra accessories, Built with powerful EMAX power system and open source flight
controller to ensure power and customizable (RTF model can fly after battery and propellers installed)
3
． The sturdy copter frame has extensive flight test and endurance test.
4． Bright COB rear LED, different LED color can use distinguish copters when group flying (LED power
consumption is 4W, which might decrease flying times.)
5
． All in one design to combine ESC, BEC, and flight controller for easy installation and easy
replacement. Plug and play motor, easy for swapping motor and no soldering needed.
7． Independent. Independent ESC and flight controller and power supply. ESC switches to perform single
ESC calibration and boot pad to perform software and firmware upgrade.
8． Flight controller use 32bit ARM micro processor, fast process speed to ensure fast respond
9． Gyroscope, magnetometer, and accelerometer and barometer expansion port. With CPPM receiver GPS feature can
be expanded. (GPS module sold separately)
10． Support ANGLE, HORIZON, HEADFREE, MAG, HEADADJ ...etc modes.
11． Support RC Input: standard signal, CPPM (PPM SUM) signal, PWM singal.
12． Low voltage monitoring and low voltage warning. (Buzzer sold separately)
13． Use EMAX 12A ESC, support open source BLHeli and ONESHOT feature; flight controller is based
on NAZE32 Skyline32, support open source configurator Baseflight and Cleanflight
14． Extra power output and power output switch for LED, tracker and other expansion.
To Next Page
Loading...
Need help?
General
