Turning ON your AV equipment
• To operate your Audio Visual (AV) components, press the volume
button on any existing remote control, press any button on the
Bluetooth™ Smart Sensor, or use the emberconnect™ app to switch
on the power to your AV equipment. This will apply power to all
components making them ready for use. Now use your existing
remote(s) to operate your television or other Audio Visual (AV)
components in the normal way.
NOTE: To reactivate your TV components, you may be required
to press the power button again on the relevant remote
control after power has been restored. You may hear a ‘click’,
or notice that the TV standby light has switched on.
Turning OFF your AV equipment
• Simply turn your equipment off in the normal way. The Embertec
Emberstrip® 8AV+
will then remove power from the Power Saving
sockets after a delay of approximately 1 minute.
NOTE: The LED light on the Bluetooth® Smart Sensor will
flash for about 60 seconds to warn you that power is about
to be removed from the AV Power Saving sockets.
Active Powerdown®
• If your Embertec Emberstrip® 8AV+ has not detected use of a remote
control for 1, 2 or 8 hours (depending on your settings), Active
Powerdown® will shut down power. The LED light on the Bluetooth®
Smart Sensor will flash for approximately 10 minutes to warn you.
Quick operation guide
A flashing light means
the system is getting
ready to shut down.
TO CONTINUE
USING YOUR
EQUIPMENT
Press the volume
button on your
remote control.
4
To Next Page
Loading...