Embrace™ Nest Operation Manual (0602-50001-002) Page 17
“OK TO USE” STATE: When the WarmPak™ is within the correct operating temperature range,
the temperature indicator bar will be in the OK region as shown on the left. This indicates that
the WarmPak™ is ready to use, and can be placed into the BabyWrap™.
“TOO COLD” STATE: When the WarmPak™ has given up all the stored heat energy, and drops
below the operating temperature threshold, the temperature indicator bar will be in the TOO
COLD region as shown on the left. This indicates that the WarmPak™ has run out of energy,
and must be immediately removed from the BabyWrap™. The WarmPak™ will need to be
recharged in the AccuTemp™ Heater before it can be re-used.
“TOO HOT” STATE: There is a third state that will not be seen if the WarmPak™ is used
correctly as indicated with the AccuTemp™ Heater.
In the event that the heater malfunctions due to improper use, or an alternate heating method
is used to heat the WarmPak™, the WarmPak™ temperature may rise above 41 °C. The
WarmPak™ indicator will be as shown on the left.
This indicates to the user that the WarmPak™ is too hot to be used, and under no
circumstances should the WarmPak™ be used, if the overheating indicator is displayed.
WARNING
It is important to pay careful attention to the WarmPak™ temperature indicator. The WarmPak™
must be used only if the temperature indicator indicates that the WarmPak™ is ready for use.
When in use for warming newborns, it is important to observe the temperature indicator at regular
intervals (every 30 minutes) to ensure that the WarmPak™ is within the operating temperature.
To Next Page
Loading...