Embrace™ Nest Operation Manual (0602-50001-002) Page 23
WARNING
Use utmost care while replacing the fuse.
Ensure that the heater power cord is unplugged from the socket. Ensure that your hands are dry,
before removing the fuse-holder cap.
Place the Heater on an insulated surface before unscrewing the fuse cap.
After replacing the fuse, ensure that the fuseholder cap is screwed in completely and tighly.
Only use a 3.15 slow blow fuse as a replacement, DO NOT use a higher or lower rated fuse.
2. The electronic circuit is damaged
Exposure to adverse power conditions may sometimes do more damage than simply blowing the
fuse. These may damage the internal circuitry of the AccuTemp™ Heater. In the event the
internal circuit is damaged, and the AccuTemp™ Heater does not turn on even after replacing
the fuse, the AccuTemp™ Heater will need to be repaired or replaced
In case of such an event occurring, the user is advised to switch off power, unplug the AccuTemp™
Heater, and contact our Customer Helpline (1800 1033 123)
4.5 SAFETY INSTRUCTIONS FOR WARMPAK™
• Ensure that the WarmPak™ does not have any tears or leaks before using it
• Do not bring any sharp-edged objects near the WarmPak™
• Place the WarmPak™ with the PCM side on the AccuTemp™ Heater surface. Align the
WarmPak™ when placing in the AccuTemp™ Heater, as shown below
• Only use the AccuTemp™ Heater provided with the unit to heat the WarmPak™. Heating it by
other methods is not safe and may result in injury to the newborn
• Use the WarmPak™ only in conjunction with the BabyWrap™. Do not use the WarmPak™ with
any other newborn interface. Embrace Innovations cannot guarantee the performance of the
WarmPak™ when used with a newborn interface other than the BabyWrap™
To Next Page
Loading...