embrace nest - Chapter 5: Using the Embrace Nest; Setting Up the AccuTemp Heater; Initiating the Heating Cycle

Embrace™ Nest Operation Manual (0602-50001-002) Page 26
CHAPTER 5: OPERATING THE WARMER
This chapter contains step-by-step instructions on operating the Embrace™ Nest. It is advisable to go
through this chapter in detail and clarify any questions or concerns with an Embrace Innovations
representative before operating the device.
The illustrated instructions-for-use section, at the beginning of this manual, can be used as a quick
reference once the user is more comfortable with the detailed instructions described below.
5.1 CHECKING EQUIPMENT BEFORE USE
Before operating the Embrace™ Nest check for the following and do not use if there are any signs of
damage as described below:
1. BabyWrap™ - Examine the lining material for signs of deterioration and any wear and tear of the
BabyWrap™. Ensure that the BabyWrap™ has been washed and disinfected before use
(especially the inner areas of the newborn compartment).
2. WarmPak™ - Examine for any wear and tear or leakage. Also ensure that the WarmPak™
temperature indicator is firmly attached to the WarmPak™ and is not peeling off.
3. AccuTemp™ Heater- Plug in the device and switch on the main power supply. Check that the
“Power ON” indicator illuminates. This ensures that the AccuTemp™ Heater is receiving power
and functioning properly. In case of an error indicator (see 4.4 ERROR INDICATORS FOR THE
ACCUTEMP™ HEATER), turn the AccuTemp™ Heater off and contact the Customer Helpline
1800 1033 123.
Refer to 6.2 MAINTENANCE & STORAGE for directions on when to discard WarmPak™.
CAUTION
Do not use the following cleaning solutions for cleaning:
- Solutions that contain Methyl Ethyl Ketones, tolulene and/or acetones.
- Solutions that have been known to injure infant skin or are toxic to infants
5.2 GETTING READY
Before using the Embrace™ Nest complete the following steps:
1. Ensure that all the components of the Embrace™ Nest are in good condition as mentioned in the
section above.
2. Sanitize the WarmPak™ and the BabyWrap™ using one of the recommended cleaning liquids
6
6.1 CLEANING
.
For detailed instructions refer to .
3. Ensure that the AccuTemp™ Heater WarmPak™ tray is clean.
The metal sensor on the inside of the AccuTemp™ Heater lid must be cleaned before use. It is what
detects the WarmPak™ temperature and ensures it is heated to the correct temperature.
6
Refer to Glossary of terms for a list of recommended cleaning liquids