embrace nest - BabyWrap Safety and Hygiene; BabyWrap Inspection and Newborn Placement; Newborn Hygiene and Sanitization

Embrace™ Nest Operation Manual (0602-50001-002) Page 24
• Do not place the newborn directly on the WarmPak™
• Always insert the WarmPak™ in the WarmPak™ compartment of the BabyWrap™. Make sure
that the WarmPak™ is correctly oriented when inserting. The water layer of the WarmPak™
faces the newborn, as shown below
• Before using the WarmPak™, check the WarmPak™ temperature indicator and ensure that it
indicates that the WarmPak™ is ready to use. Do not use the WarmPak™ if the temperature
indicator is damaged or torn or peeling off from the WarmPak™
• Do not expose the WarmPak™ to Ultraviolet rays or leave it under the sun
• Store the WarmPak™ in a dry place, preferably at room temperature. Do not refrigerate the
WarmPak™
• Always store the WarmPak™ flat on a clean flat surface. Do not fold it, or store it in the
AccuTemp™ Heater
• Do not consume the contents of the WarmPak™
• Use the WarmPak™ only for the purpose of providing warmth to a newborn in the BabyWrap™.
Do not use it in any manner other than as prescribed
• Replace the WarmPak™ immediately if the temperature indicator peels off or is damaged
• Refer to 6.2 MAINTENANCE AND STORAGE for directions on when to discard WarmPak™.
CAUTION
Do not use the following cleaning solutions for cleaning:
• Solutions that contain Methyl Ethyl Ketones, tolulene and/or acetones.
• Solutions that have been known to injure infant skin or are toxic to infants