Embrace™ Nest Operation Manual (0602-50001-002) Page 28
8. If for some reason the heating cycle needs to be paused, press the Start/Stop button to pause
the heating cycle. This will turn off the “HEATING CYCLE ON” indicator. Press the Start/ Stop
button again when you wish to restart the heating cycle.
NOTE
The Start/Stop button will only work when the AccuTemp™ Heater lid is closed and latched in place.
Press the Start/Stop button and ensure that your action has registered correctly by checking to see if
the “HEATING CYCLE ON” indicator has turned on/off.
9. After approximately 35 minutes, the buzzer will beep once to indicate that the heating cycle is
complete, and will beep once again a minute after that. The “WARMPAK™ READY” indicator will
turn on and stay illuminated (green) indicating the WarmPak™ is ready for use.
NOTE
Some un-melted wax may remain in the WarmPak™ even after the AccuTemp™ Heater indicates the
heating is complete. This is completely normal, and should not be treated as an error.
The WarmPak™ may be slightly distorted or crumpled after use. This is perfectly normal, and the
WarmPak™ may be reused as usual.
To Next Page
Loading...