EasyManua.ls Logo

EMC VNX5300 - Page 7

EMC VNX5300
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VNX5300 Block and File front and rear views
7
EMC® VNX5300™ Hardware Information Guide
Four-port 1-Gb/s 10/100/1000 copper iSCSI
Four-port 8-Gb/s optical Fibre Channel (running at 2, 4, or 8-Gb/s)
Two-port 10-Gb/s optical or active Twinax
2
Fibre Channel over
Ethernet (FCoE)
One RS-232/EIA 232 serial (up to 115 K baud) service laptop (micro DB-9)
port
One RS-232/EIA 232 serial management (micro DB-9) port
One 10/100/1000 LAN management (RJ-45) port
One 10/100/1000 LAN service (RJ-45) port
One power supply (hot-swappable)
One (1U) standby power supply (SPS) with a second (optional) SPS available
One DME with up to two Data Movers. Each Data Mover consists of:
One CPU module consisting of one Intel Xeon 4-core 2.13-GHz processor
Six DDR3 synchronous dynamic RAM (SDRAM) slots supporting up to 6 GB
per CPU module
One Fibre Channel (FC) I/O module with a:
Four-port 8 Gb/s optical (running at 2, 4, or 8 Gb/s); in slot 0
One to two of the following network I/O modules in any combination:
Two-port 10-Gb/s optical or active Twinax
2
(w/iSCSI protocol)
Four-port 1-Gb/s copper iSCSI
Two-port 1-Gb/s copper plus two-port 1-Gb/s optical
Two-port 10-Gb/s optical or active Twinax
2
Fibre Channel over Ethernet
(FCoE)
Note: The maximum number of I/O modules for the VNX5300 is three per Data Mover
and any combination of these I/O modules must be the same for each Data Mover.
Two management modules per DME (or, one per Data Mover)
Two power supply/cooling (fan) modules per CPU module
One or two Control Stations. Each Control Station consists of the following
features:
Intel 2.0 GHz single core Celeron processor with 800-MHz front side bus (FSB)
and 512 KB cache
•2 GB of RAM
One 250 GB SATA hard drive
Two rear-mounted USB ports and one front-mounted USB port
Four 10BASE-T/100BASE-TX/1000BASE-T network interface (RJ-45)
connectors (located on the rear panel)
Two integrated serial ports, one for laptop/console redirection and one for the
CallHome modem
One DVD-ROM drive
Expansion of up to seven 3U, 15 (3.5-inch) DAEs (a maximum of 120 drives) or up
to four 2U, 25 (2.5-inch) DAEs (a maximum of 125 drives)

Other manuals for EMC VNX5300

Related product manuals