EMC VNXe3100 - Replace the memory module

Replacing a VNXe3100 Memory Module4
Remove the memory module from the storage processor, and install the replacemen:.
1. Rotate the memory module latches outward to release the module from the socket.
2. Touching only the outside edges of the memory module, pull the module directly out of the socket,
and place it on an antistatic surface.
3. Remove the replacement memory module from its antistatic bag.
4. Handling only the outside edges of the module, align the module with the socket.
Note: The socket and module are keyed to prevent incorrect alignment.
5. Firmly push the module directly into the socket.
6. The latches will snap to the closed position when the module is fully inserted in its socket.
2
1
3
4
DIMM 0
DIMM 1
Task 3: Replace the memory module