Replacing a VNXe3100 Memory Module6
Replace the SP assembly in the enclosure:
1. Pull out the latches on each side of the SP and make sure they stay in the open position.
2. Align the SP with the chassis opening and push it straight into the chassis.
The latches begin to close when they contact the chassis edges.
3. Close the right and left latches to fully seat the SP in the chassis.
An audible click indicates that the latches are secure.
4. Reconnect the cables to the back of the storage processor.
• Connect all cables to the same ports from which you removed them on the faulted SP assembly.
• The SP begins powering up immediately after connection to an active AC power source.
Task 5: Replace the storage processor
To Next Page
Loading...
