To Next Page

This document describes how to replace a faulted input/output (I/O) module in a

VNXe3100 or VNXe3150 disk processor enclosure (DPE). For information on upgrading the

existing I/O modules in a VNXe3100 or VNXe3150 DPE with a different type of I/O module,

refer to the document for upgrading I/O modules in a VNXe3100 or VNXe3150 system.

Before you start

Before you begin the procedure, refer to your EMC® VNXe™ online help (Servicing your

system > Adding or replacing faulted hardware components > Replace a faulted hardware

component) for instructions on how to identify failures, order new parts, and handle

hardware components.

Tasks to replace an I/O module

◆ Task 1: Preparing the storage processor (SP) for service ............................................ 2

◆ Task 2: Remove the SP assembly............................................................................... 3

◆ Task 3: Remove the SP top cover ............................................................................... 4

◆ Task 4: Remove the faulted I/O module..................................................................... 5

◆ Task 5: Install the replacement I/O module ............................................................... 6

◆ Task 6: Replace the SP top cover ............................................................................... 7

◆ Task 7: Install the SP assembly ................................................................................. 7

◆ Task 8: Reboot the storage processor ........................................................................ 8

◆ Task 9: Verify the operation of the replacement I/O module....................................... 8

◆ Task 10: Return the faulted I/O module ..................................................................... 8

EMC

VNXe3100/VNXe3150

Replacing an Input/Output Module

P/N 300-012-217

REV 02

EMC VNXe3100 Quick Sart Guide

Other manuals for EMC VNXe3100