DIGITAL CONDUCTIVITY METER
The information contained in the accompanying document is proprietary and confidential, and may not be
copied in any manner whatsoever without prior written consent of Emcee Electronics, Inc. The document
and the material therein may not be used for any purpose other than that intended by Emcee Electronics,
Inc.
COPYRIGHT 1984 EMCEE ELECTRONICS, INC.
REVISION DATE: JANUARY 10, 2019
Page 7 of 20
5.7 The Accessory Cable Kit shown in
Figure 6 includes a portable reel with
a 50' cable . This kit enables the
operator to connect the probe to the
50' cable for use in a large tank. The
kit also is supplied with a grounding
cable for attachment between the
conductivity meter and tank ground.
6.0 PREPARATION OF SAMPLE
The sample container (preferably a one liter
metal container) should be cleaned with a
solvent and rinsed with the fuel to be
tested. After the sample for test has been
withdrawn, wait approximately two minutes for
charges in the fuel to dissipate.
To Next Page
Loading...
