October 2014
2
Quick Start Guide
NOTICE
This guide provides basic guidelines for the Emerson 1410 Smart Wireless Gateway. It does not
provide instructions for diagnostics, maintenance, service, or troubleshooting. Refer to the
Emerson Smart Wireless Gateway 1410 Reference Manual (document number
00809-0200-4410) for more information and instructions. The manual and this guide are
available electronically on www.emersonprocess.com.
Explosion Hazard - Do not make or break any connections to the 1410 while circuits are live
unless area is known to be non-hazardous. Explosions could result in death or serious injury:
Installation of this device in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Please review the
Product Certifications section for any restrictions associated with a safe installation.
Avoid contact with the leads and terminals. High voltage that may be present on leads can
cause electrical shock. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following conditions. This device may not cause harmful interference. This device must
accept any interference received, including interference that may cause undesired operation.
This device must be installed to ensure a minimum antenna separation distance of 20 cm from
all persons.
Potential Electrostatic Charging Hazard
The 1410 enclosure is plastic. Use care in handling and cleaning when in explosive environments
to avoid an electrostatic discharge.
Contents
Wireless Considerations . . . . . . . . . . . . . . page 3
General considerations . . . . . . . . . . . . . . . page 3
Initial connection and configuration . . . page 4
Physical installation . . . . . . . . . . . . . . . . . . page 9
Software installation (optional) . . . . . . page 13
Verify operations . . . . . . . . . . . . . . . . . . . page 14
Product Certification . . . . . . . . . . . . . . . . page 15
Declaration of Conformity . . . . . . . . . . . page 17
00825-0200-4410_CA.fm Page 2 Thursday, October 16, 2014 6:44 PM