Emerson AMS Wireless Vibration Monitor User Manual

B.5 Hazardous locations certifications
Model No:: A9530
Product Name: Wireless Vibration Monitor
The AMS Wireless Vibration Monitor carries certificates for operation in hazardous
locations.
Table B-2: Hazardous locations certifications
CSA C/US Certificate
CSA20CA80026524
Class I Division 1 Groups A, B, C, D
Class I Zone 0 AEx / Ex ia IIC T4 Ga
-40ºC ≤ Ta ≤ +85ºC
Type 4X Enclosure
IECEx Certificate IECEx CSA 20.0002X Ex ia IIC T4 Ga
Ta: -40ºC to +85ºC
ATEX Certificate CSANe
20ATEX2042X
II 1 G Ex ia IIC T4 Ga
-40ºC ≤ Ta ≤ +85ºC
IP66
Other approvals
For a complete list of approvals, see the product page at http://www.emerson.com/
AMSVibrationMonitor.
Conditions for Safe Use
1. Shall be powered only by C-sized lithium primary cell type TL-4920/VE
manufactured by Tadiran or Emerson Part Number A0702PPU.
2. HART Terminal Entity Parameters:
Uo = 5.84V, Io = 116mA, Po =169mW, Co = 0.1µF, Lo = 5mH;
Ui = 5.27V, Ii = 5mA, Pi = 6.6mW, Ci = 13 µF, Li = 0.022mH
3. The device may be configured using the HART terminals only by 375, 475, or TREX
field communicators.
4. Under certain extreme circumstances, the non-metallic parts incorporated in the
enclosure of this equipment may generate an ignition-capable level of electrostatic
discharge. Therefore, the equipment shall not be installed in a location where the
external conditions are conductive to the build-up of electrostatic charge on such
surfaces. In addition, the equipment shall only be cleaned with a damp cloth.
5. The device shall be installed on an earthed metal frame.
Note
Battery may be replaced in hazardous locations. Only replace battery with Tadiran Part
Number TL-4920/VE or Emerson Part Number A0702PPU.
User Guide Product certifications
MHM-97927-PBF August 2020
MHM-97927-PBF, Rev 1 77

Emerson AMS Wireless Vibration Monitor Specifications

General

Brand	Emerson
Model	AMS Wireless Vibration Monitor
Category	Monitor
Language	English