Emerson AMS - Device Configuration; Configuration Setup Options

2 Configuration
2.1 Configuration setup
Unless the AMS Wireless Vibration Monitor is purchased pre-configured from the factory,
it needs to be configured prior to installation at the facility or measurement location.
There are three possible setups to configure the device:
1. Connect the device to a field communicator, and then configure the device using
the field communicator.
Note
This setup is recommended if you are in a hazardous area.
2. Connect the device to a computer through a HART modem, and then configure the
device using AMS Device Manager.
Note
The HART modem is purchased separately.
3. Connect the device to a computer through a wireless gateway and then configure
the device using AMS Device Manager.
Note
This setup is recommended for standard device configuration.
User Guide
Configuration
MHM-97927-PBF July 2020
MHM-97927-PBF, DRAFT 13