Emerson ASHLAND CF717BS00 - Installing the Light Kit Assembly; Connect Light Kit to Motor; Attach Light Kit and Install Bulbs

15
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF717
11. Installation of Light Kit Assembly
11.2
Remove one switch cup plate screw and retain for
future use. (Figure 24). Loosen the two switch cup plate
screws.
Position the light kit assembly notched holes onto the
switch cup plate’s two loosened screws.
Rotate the light kit assembly clockwise to engage the
two screws (Figure 24).
Secure the light kit assembly by installing the previous
removed screw (Figure 24).
SWITCH
CUP PLATE
SCREW (3)
LIGHT KIT
ASSEMBLY
ROTATE LIGHT KIT ASSEMBLY CLOCKWISE
Figure 24
11.1
Engage the connector of the light kit assembly with the
motor connector (Figure 23).
The two connectors are keyed and color-coded and
must be mated correctly (color-to-color) before they can
be engaged.
Make sure the connector latch closes properly.
MOTOR
CONNECTOR
LIGHT KIT
ASSEMBLY
CONNECTOR
LIGHT KIT
ASSEMBLY
Figure 23
To avoid possible fire or shock, do not pinch wires
between the light kit assembly and the switch cup
plate.
WARNING
!
LIGHT KIT
ASSEMBLY
SOCKETS (3)
60-WATT
(maximum)
CANDELABRA
BASE BULBS (3)
Figure 25
11.3
Screw the three 60-watt (maximum) candelabra base
bulbs in the light kit assembly sockets (Figure 25).
To avoid risk of burns or other injuries, turn power off
and allow lamps to fully cool before attempting to
replace the candelabra base bulbs.
WARNING
!
Over lamping the fan will result in the lamps being
automatically shut off. Use only 60 watt maximum
candelabra base bulbs. Turn off the electricity before
replacing the bulbs.
WARNING
!
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 15