Emerson Branson CPX5800H - Figure 6.2 MH Series Controls; Table 6.6 MH Series Explanation of Controls; Table 6.7 for Initial Cleaning Solution Degassing

100-214-294 REV. 05 35
6.3.1 MH Series Explanation of Controls
Figure 6.2 MH Series Controls
6.3.2 Degassing
Table 6.6 MH Series Explanation of Controls
Control Function
Main Power
Switch
This switch is located on the back of the unit, next to the power
cord receptacle.
• Press the on side to power on the unit
• Press the off side to power off the unit
When operating the unit, normally leave the Main Power switch in
the (on) position, and use the Timer Knob to activate ultrasonics.
Heat Switch
Activates heat to 60° C (140° F) maximum.
NOTICE
Refer to 4.3 Temperature for further information on temperature.
Timer Knob
Activates ultrasonics and sets time.
• Turn clockwise for timed operation (0–60 minutes)
• Turn counterclockwise to the HOLD position for continuous operation
Turn to the zero position to turn unit Off.
Table 6.7 For initial cleaning solution degassing.
Step Action
1 Turn Main Power switch on.
2 Turn Heat switch on.
3
Turn the Timer Knob clockwise to 5–10 and let the unit run to allow the
solution to “degas”.
NOTICE
Refer to 6.5.11 Solution for information on degassing.