100-214-294 REV. 05 41
6.4.4 Cleaning Items (Treating Samples)
4
After completing the degas time, you are ready to set operating
parameters.
Table 6.12 Degassing your CPX Series unit
Step Action
NOTICE
To stop ultrasonics at any time, press the Sonics key.
Table 6.13 Treating Samples
Step Action
1 Turn Main Power switch on.
2 Press the On/Standby key to turn on the unit.
3
Set the amount of time you wish the items to be cleaned, or select
Constant Sonics Mode:
• Use Up/Down keys to increase/decrease cycle time (hold for quick increments/
decrements)
• Pressing Up key from 99 minutes or Down key from 1 minutes takes you to
Constant Sonics Mode (Constant Sonics icon and “- -” display on the LCD
screen)
4 Press the Sonics key to activate ultrasonics.
5
Place the items into a basket, perforated tray, or beakers in a positioning
cover.
6
If using beakers or a solid tray, add cleaning solutions to beakers or tray
to cover the items.
7
Slowly lower the tray or beakers into the tank. Do not allow items to
contact the tank bottom.
8 When items are clean, slowly remove them from the tank.
9 Rinse clean items with clean, warm water and dry, if necessary.
To Next Page
Loading...