18
U.L. Model No.: CF144 & CF152
FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
T
ROUBLESHOOTING YOUR FAN.
WARNING
!
12. Troubleshooting
Make sure main power is turned OFF.
WARNING
!
Make sure main power is turned OFF.
WARNING
!
TROUBLE PROBABLE CAUSE SUGGESTED REMEDY
1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers.
2. Loose power line connections to the fan. 2. Check line power connections to fan.
3. Fan/Light remote control is OFF. 3. Turn ON Fan/Light remote control.
2. Fan sounds 1. Blades not attached to fan. 1. Attach blades to fan before operating.
noisy.
2. Screws securing fan blades to motor are loose. 2. Check to make sure the screws which attach the blades to
the motor are tight.
3. Fan wobbles 1. Screws securing fan blades to motor are loose. 1. Check to be sure screws which attach the fan blade to the
excessively. motor are tight.
2. Fan blades are not seated properly. 2. Check to be sure that the screws securing the fan
blades seat firmly.
3. Fan blades out of balance. 3. Interchanging an adjacent (side by-side) blade pair can
redistribute the weight and result in smoother operation.
Or use supplied balancing kit to balance blades.
4. Both lamps will 1. Loose electrical connectors. 1. Shut off the branch circuit electricity at the fuse box or
not illuminate. breaker panel and check the receiver electrical connectors
for proper installation.
2. Remote control battery is weak. 2. Replace the AAA remote batteries.
3. The lamps are burnt out. 3. Turn the electricity off and replace the lamps with new
50W max. lamps.
4. Lamps turn on and then turn off. 4. The built in circuit breaker is tripping, check that the lamps
are each 50W maximum.
CAUTION: Turn the lights off before touching halogen
lamps, they are very hot and can burn your fingers.
To Next Page
Loading...
