* In case of replacement of the piston con-rod assemblies, clean the Torx screws and apply Loctite
2701.
The ranges of torque values given in this specification are
assembly torques. Torque after joint relaxation must be within
15 % of the minimum assembly torque unless re-torque is called
for and must not be above 10 % of the maximum assembly torque.
DISCLAIMER
1. The contents of this publication are presented for informational purposes only and are not to be
construed as warranties or guarantees, express or implied, regarding the products or services
described herein or their use or applicability.
2. Emerson Climate Technologies GmbH and/or its affiliates (collectively "Emerson"), as applicable,
reserve the right to modify the design or specifications of such products at any time without notice.
3. Emerson does not assume responsibility for the selection, use or maintenance of any product.
Responsibility for proper selection, use and maintenance of any Emerson product remains solely
with the purchaser or end user.
4. Emerson does not assume responsibility for possible typographic errors contained in this
publication.
To Next Page
Loading...
