TROUBLESHOOTING
PROBLEMS CHECK
LINE REDIAL
Check if shows in the display. Since the redial
button has combined function (pause function), the
phone may have been paused. Just press the
HOOK switch.
Feedback or squealing when
using SPEAKERPHONE.
Volume is too high. Reduce the SPEAKERPHONE
VOLUME control setting.
Cannot erase all records in
memory
To erase ALL call records, make sure the phone
is not in use, press the delete button and hold
for 3 seconds, the display will show “DELETE
ALL?”, press the delete button again.
Caller ID displays words like
Your language is set for French or Spanish. Refer
to page 7 “ Options Menu” to change the language
setting to English
Memory Dialing does not work.
Check if you have stored the numbers correctly
by pressing that memory location button(s). Also
numbers can only be stored when fresh batteries
are installed correctly
.
Handset falls out of phone
base when wall mounted.
Handset clip was not installed properly for wall use.
Caller’s information is not
registered to the Caller ID
memory.
The caller may have an unlisted or blocked number
to prevent Caller ID identification, or it may be an
overseas call or you may have noise on the line
during that call.
Message Waiting does not
work.
Check with your telephone company if this service
is available and if you have subscribed for it.
Pressing a memory button
does not display number.
Your memory button has no stored number
.
Please store the number again. Press the store
button, dial the number and press the memory
locations you want.
CO IS IS ZONE, CCODIGO DE AREA
or HORA or APPEL or TEMPS.
does not work.
“P”
11
To Next Page
Loading...
