DVC2000 Digital Valve Controller
July 2009
7-2
Parts Ordering
Whenever corresponding with your Emerson Process
Management sales office about this equipment,
always mention the controller serial number. When
ordering replacement parts, refer to the 11-character
part number of each required part as found in the
following parts list. Parts which do not show part
numbers cannot be ordered.
WARNING
Use only genuine Fisher replacement
parts. Components that are not
supplied by Emerson Process
Management should not, under any
circumstances, be used in any Fisher
instrument. Use of components not
supplied by Emerson Process
Management may void your warranty,
might adversely affect the
performance of the valve, and could
cause personal injury and property
damage.
The DVC2000 digital valve controller is designed with
all metric fasteners and threaded connections.
However, optional inch connections are available for
the two conduit entrance points (1/2 NPT) and the
supply/output pneumatic ports (1/4 NPT). Even with
this option, all other fasteners and threaded
connections are metric.
Note
Neither Emerson, Emerson Process
Management, nor any of their affiliated
entities assumes responsibility for the
selection, use, or maintenance of any
product. Responsibility for the
selection, use, and maintenance of any
product remains with the purchaser
and end-user.
Parts Kits
Description Part Number
Terminal Board Kit (positioner only) GE08906X012
Terminal Board Kit (positioner, transmitter,
limit switches) GE08907X012
I/P Converter Kit 38B6041X122
Description Part Number
Low Pressure Relay Kit (white label)
(0 − 3.4 bar, 0 − 49 psig) GE08910X012
High Pressure Relay Kit (green label)
(3.5 − 7.0 bar, 50 − 100 psig) GE08911X012
Mounting Frame Kit GE08912X012
Main Cover Assembly (see figure 7-1, key 13) GE12427X012
EMI Shield Kit GE08913X012
25 mm (1-inch) Feedback Array GE09169X012
50 mm (2-inch) Feedback Array GE09170X012
100 mm (4-inch) Feedback Array GE43790X012
Rotary Feedback Kit GE09171X012
Elastomer Kit − includes all accessible elastomers
for one complete DVC2000 unit GE08917X012
Small Hardware Kit −includes all fasteners and plugs
(except mounting hardware) for one
complete DVC2000 unit GE08918X012
High Temperature Gasket Set GE26550X012
Includes O-ring seal (qty 1) and insulation
gaskets (qty 2)
Parts List (refer to figures 7-1, 7-2
and 7-3)
Note
The parts contained in the Parts List
are not available as individual
components. All parts are included in
the Parts Kits.
Key Description
Terminal Board Assembly
(1)
4 Feedback Sensor & Termination Boards , with Options
11 Fasteners
15 Fastener
24 Conductive Gasket (PWB)
29 Conductive Gasket (Shield)
30 Fastener
32 O-ring seal
36 Terminal Barrier
42 Fasteners
43 Interconnect and I/P Boards
7
1. All parts included in the Terminal Board Kits
To Next Page
Loading...
