DVC2000 Digital Valve Controller
July 2009
Index-2
Check Supply, 3-13
Clear Record, 4-12
Communication Connections, 2-12
Component Replacement, 6-3
Config & Calib, 4-4
Connections
Electrical, 2-9, 2-10
Supply, 2-9
Control Mode, 4-4
Critical NVM Fail, 4-12
Self Test Failure, enabling to cause
instrument shutdown, 4-12
Critical NVM Failure, 5-4
CSA
Approvals Nameplate, C-2
Hazardous Area Classification, 1-4
Loop Schematic, C-1
Special Conditions of Safe Use, 2-2
Custom Char Selected, 5-4
Cycl Cnt Alrt Enab, 4-11
Cycl Count Alrt Pt, 4-11
Cycle Counter
Displaying Value, 5-2
Enabling Alert, 4-11
Resetting, 4-11
Cycle Counter Alert, 5-3
Cycle Counter Alert Enable, 4-11
Cycle Counter Alert Point, 4-11
Cycle Counter Deadband, 4-11
D
Date, 4-6
Declaration of SEP, 1-5
Descriptor, 4-6
Detailed Setup, via Local Interface, 3-8
Device ID, 5-3
DVC2000, Hardware, 5-3
Device Information, 5-2
Device Locked by HART, 3-13
Device Rev, 5-3
Device Revision, 5-3
Diagnostic in Progress, 5-4
Diagnostic Messages, Codes and Details,
3-13
Check I/P Converter, 3-13
Check Mounting, 3-13
Check Supply, 3-13
Device Locked by HART, 3-13
Pressure = ???, 3-13
Replace Main Board, 3-13
SWITCH 1 ???, 3-13
SWITCH 2 ???, 3-13
Travel Deviation, 3-13
Digital Calibration Adjust, 4-14
Display Record, 4-12
Drive Alert Enable, 4-11
Drive Alrt Enab, 4-11
Drive Current Fail, 4-12
Self Test Failure, enabling to cause
instrument shutdown, 4-12
Drive Current Failure, 5-4
Drive Signal, 5-2, A-2
Displaying Value, 5-2
Enabling Alert, 4-11
Drive Signal Alert, 5-3
E
Electrical Classification, 1-4
Electrical Connections, 2-9, 2-10
Electromagnetic Compatibility, 1-4
F
Factory Default Settings, 3-5
Failure Alerts, 5-4
Critical NVM Fail, 5-4
Drive Current Fail, 5-4
Flash ROM Fail, 5-4
No Free Time, 5-4
Offline/Failed, 5-4
Pressure Sensor Fail, 5-4
Ref Voltage Fail, 5-4
Temperature Sensor Fail, 5-4
Travel Sensor Fail, 5-4
Feedback system, 2-4
Field Communicator
Device Description Revision, B-6
C
Index
To Next Page
Loading...
