FXMP25 User Guide 27
Issue Number: 3 www.controltechniques.com
Safety information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Parameters Setting-up Technical data Diagnostics UL listing information
5 Getting started
5.1 Keypad and display
The display will show different information depending on the display mode selected.
There are three display modes as shown below.
Figure 5-1 Display modes
Figure 5-2 Selecting and changing parameters
When in status mode pressing and releasing the MODE key will change the display
from status mode to parameter view mode.
In parameter view mode, the left hand display flashes the parameter number and the
right hand display shows the value of that parameter. The left hand display flashing
indicates that the up and down keys will select a different parameter to be
viewed. Holding the up key will cause the parameter number to increment to Pr 99.
M
STORED CHARGE
10 min
Mode /Reset
FXMP25
Status mode
Parameter view mode
Parameter edit mode
M
STORED CHARGE
10 min
Mode /Reset
FXMP25
10 min
Mode /Reset
FXMP25
Status
Parameter
value
Parameter
number
(flashes)
Parameter
value
Parameter
number
Parameter
M
STATUS MODE
or
PARAMETER VIEW MODE
Select parameter to view
orPress
Parameter number flashing
PARAMETER EDIT MODE
Change parameter value
orPress
Parameter value flashing
M
Press and
release
M
Hold
for 2s
4 mins
Press and
release
Press and
release
Press and
release
M M