Emerson i2P-100 - Page 14

i2P-100 Transducer
Instruction Manual
Form 5777
September 2004
14
NOTE:
APPLY LUBRICANT/SEALANT/ADHESIVE
30C2230-A / IL
Figure 13. Type i2P-100 Transducer Assembly
PWB/Cup Assembly
24* PWB/Cup Assembly GE10168X012
97 Machine Screw (2 req’d) GE11776X012
98 Machine Screw GE11777X012
Relay Assembly (see figure 14)
41 Relay / Body Assembly GE03512X012
42 O-Ring 1E5477X0062
36 Machine Screw, fill hd (4 req’d) 1H1581X0012
32 Body Plug 11B2363X012
33 Exhaust Port Assembly 11B2364X012
34 Spring 11B2369X012
35 Spring 11B6843X012
38 Upper Diaphragm 21B2362X012
39 Valve Plug 21B2370X012
40 Body Block 31B2356X012
I/P Converter Assembly
43* I/P Converter Assembly 30C2218X012
Gauge/Pipe Plug
23 Pipe plug, use when gauge is not specified (not shown)
Alloy steel pl 1C333528992
Stainless steel 1C3335X0032
23 Gauge, (not shown)
0- 30 psig/0- 0.2 MPa/0- 2 bar 11B8579X022
0- 60 psig/0- 0.4 MPa/0- 4 bar 11B8579X032
*Recommended spare parts