Emerson i2P-100 - Mounting Parts

i2P-100 Transducer
Instruction Manual
Form 5777
September 2004
15
30C2258-B/ IL
NOTE:
APPLY LUBRICANT/SEALANT/ADHESIVE
Figure 14. Type i2P-100 Relay Assembly
Key Description Part Number
Diagnostic Connections
FlowScanner diagnostic system hook-up
Includes pipe tee, pipe nipple, pipe
bushings, connector body, and body
protector. See figure 7 for part
identification. Also, part number provides
correct quantities of each item.
Note
If the Type i2P-100 Transducer is used in a
valve assembly with a positioner, no hook-up
for diagnostic testing is required for the Type
i2P-100. The hook-up for diagnostic testing
should be installed at the positioner.
Side Output
For units with gauges
SST fittings 12B8040X052
Brass fittings 12B8040X062
For units without gauges
SST fittings 12B8040X072
Brass fittings 12B8040X082
Key Description Part Number
Mounting Parts
Yoke Mounting
Type 470 size 23 through 64
80 Mounting Bracket, steel 3P426825022
81 Washer, steel pl (4 req’d) 1B865928982
82 Cap Screw, steel pl (4 req’d) 1A381624052
480 Series actuator boss
80 Mounting Bracket, steel 3P426825022
81 Washer, steel pl (4 req’d) 1B865928982
82 Cap Screw, steel pl (4 req’d) 1A381624052
83 Screw, steel pl (2 req’d) 1C5958X0022
85 Mounting Bracket, Steel 3L276725092
86 Hex Nut, steel pl (2 req’d) 1A352724122
Type 585C size 25 and 50
80 Mounting Bracket, steel 3P426825022
81 Washer, steel pl (4 req’d) 1B865928982
82 Cap Screw, steel pl (4 req’d) 1A381624052
83 Screw, steel pl (2 req’d) 1A352624052