What to do if my Emerson Liebert GXT4-5000RT208 is overloaded?
If your Emerson UPS is overloaded, it means the current load exceeds its capacity. Reduce the load by disconnecting some equipment. Contact customer service for further assistance.
Why is my Emerson Liebert GXT4-5000RT208 beeping and showing overtemperature?
If your Emerson UPS indicates an overtemperature condition, it means the UPS is overheating and will switch to Bypass mode. Reduce the load connected to the UPS and contact customer service.
What to do if Emerson UPS shows 'Battery Weak/Bad'?
If your Emerson UPS displays a 'Battery Weak/Bad' message, it indicates that the battery needs replacement. Replace the battery.
What to do if my Emerson UPS output has a short circuit?
If your Emerson UPS experiences an output short circuit, it means there's a fault in the output connection. Shut down the connected equipment and contact customer service.
What to do if Emerson Liebert GXT4-5000RT208 UPS self test failed?
If the Emerson UPS self-test fails, it suggests the battery might be weak or faulty. Contact customer service.
What to do if my Emerson UPS received shutdown command?
The Emerson UPS shuts down through communication. Contact customer service.
What to do if Emerson Liebert GXT4-5000RT208 shows 'Inverter Out of Order'?
If your Emerson UPS displays an 'Inverter Out of Order' message, it means the inverter is faulty. Contact customer service.
What to do if Emerson UPS reports 'DC Bus Overvoltage'?
If the Emerson UPS reports a 'DC Bus Overvoltage' error, it indicates a fault with the DC bus. Contact customer service.
What to do if Emerson Liebert GXT4-5000RT208 reports 'Charger Out of Order'?
If your Emerson UPS displays a 'Charger Out of Order' message, it indicates that the charger is faulty. Contact customer service.
What to do if Emerson Liebert GXT4-5000RT208 reports 'Fan Out of Order'?
If your Emerson UPS displays a 'Fan Out of Order' message, it indicates that at least one fan is faulty. Contact customer service.
General| Input Voltage | 208 V |
|---|---|
| Output Voltage | 208 V |
| Emergency Power Off (EPO) | Yes |
| Input Frequency | 50/60 Hz |
| Transfer Time | 0 ms |
| Capacity | 5000 VA |
| Output Power Capacity | 5000 W |
| Battery Type | Sealed Lead Acid |
| Input Voltage Range | 160 - 276 V |
| Topology | Online Double Conversion |
| Communication Ports | USB |
| Output Frequency | 50/60 Hz |
| Operating Temperature | 0 to 40°C |
| Humidity | 0 to 95% non-condensing |
To Next Page