12 Mini Maestro User Guide
www.controltechniques.com Issue Number: 5
Figure 3-3 Locations of the signal and power connections on the installation kits
Edge connector of the drive
When an installation kit is used, the functions of the connections on the edge connector
do not need to be known. The connections are as follows:
ing
1
18
Pin number Function
1 Signal common
2 Protection enable
3TPRC
4 –10V, 3mA supply
5 +10V, 3mA supply
6 Speed reference input [non inverting]
7 Drive enable
8 Signal common
9 Tachogenerator input
10 Speed reference input [inverting]
11 I
mot
Analog signal proportional to the effective current in the motor
14, 15, 16, 17 +DC supply input
19, 20, 21, 22 –DC supply input
24, 25, 26, 27 Motor output + [M1]
29, 30, 31, 32 Motor output – [M2]
12, 13, 18, 23 Do not use
The signal common terminals are at the same potential as the -DC supply input terminals
CAUT ION
To Next Page
Loading...
