Safety
Information
Product
information
Mechanical
Installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
SMARTCARD
operation
Onboard
PLC
Advanced
parameters
Technical
data
Diagnostics
UL
information
Mentor MP User Guide 85
Issue: 3 www.controltechniques.com
Table 9-7 SMARTCARD status indications
Lower
display
Description
boot
A parameter set is being transferred from the SMARTCARD to the
drive during power-up. For further information please refer to section
9.3.4 Booting up from the SMARTCARD on every power up (Pr 11.42
(SE09, 0.30) = boot (4)) on page 82.
cArd
The drive is writing a parameter set to the SMARTCARD during power-
up. For further information please refer to section 9.3.3 Auto saving
parameter changes on page 82.
To Next Page
Loading...
Need help?
General
