18
Radio operation
Radio operation
All radio functions can be operated by the remote.You shouldn't need to
lower the front panel flap.
Tuning-in a new radio station
Pressing BAND selects radio operation. The display indicates the tuning
frequency, and just to the right of it, the band: FM, or AM. Repeatedly pressing
BAND changes the band.
Having selected the required band, tune-in to a radio station in either of the
following ways:
To search up or down the band for a station, hold in + or - for two
seconds then release.
To change frequency one step at a time, repeatedly press and
release + or - .
You can keep any new station you've tuned-in by storing it in the memory
(see below.)
Storing radio stations in memory
You can store up to 20 radio stations on each band.
1.Tune in to the station you wish to store (as described above).
2. Decide on the memory number you will use for this station, for
example 2.
Note–For best FM reception, position the trailing FM antenna wire for
least interference. (Note if AM reception is poor, you may need to
rotate the unit.)
To Next Page
Loading...
Need help?
General
