13
SETTING THE CLOCK
Use the buttons on the unit’s front panel to carry out this procedure.
1.) Press POWER/STANDBY button to switch the unit on.
2.) Press the AUX button.
(Note the time setting flashes in the center of
the display.)
3.) Press the TIME-SET/MEMORY button so that
the hour setting flashes, then press or
button to set the correct hour (making sure the
flashing AM or PM is correct).
4.) Press TIME-SET/MEMORY so that the minute
setting flashes, then press or button to
set the correct minute.
5.) Press TIME-SET/MEMORY to finish clock
setting.
Once the time has stopped flashing, the clock is
set.
NOTE: If ever you find the whole time display is flashing, this means that the clock
needs to be re-set (possibly due to the unit having been disconnected from the AC
outlet, or a power interruption).
MS3103_ib012803.p65 28/1/2003, 11:3613
To Next Page
Loading...
Need help?
General
