EasyManua.ls Logo

Emerson QUIET KOOL EARC6RE1 - Storm Window Installation Considerations; Storm Window Clearance; Air Conditioner Operation Guide; Operating Precautions

Emerson QUIET KOOL EARC6RE1
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If AC is Blocked by Storm Window
Add wood as shown in FIG.14, or remove storm window before air
conditioner is installed.
If Storm Window Frame must remain, be sure the drain holes or
slots are not caulked or painted shut. Accumulated Rain Water or
Condensation must be allowed to drain out.
Removing AC From Window
* Turn AC off, and disconnect power cord.
* Remove sash seal from between windows, and unscrew safety
lock.
* Remove screws installed through frame and frame lock.
*Close (slide) side panels into frame.
* Keeping a firm grip on air conditioner, raise sash and carefully
"rock" air conditioner backward to drain any condensate water in
base of unit. Be careful not to spill any remaining water while lifting
unit from window. Store parts WITH air conditioner.
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the best
possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This prevents the air conditioner from blowing a
fuse or tripping a circuit breaker.
■Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65 (18). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
keep its settings and will operate at the previous settings when the
power is restored.

Related product manuals