How to Install
NOTE: Top Rail and Sliding Panels at each side are offset to
provide a proper pitch towards the rear of 5/16".
This is necessary for proper condensed water utilization and
drainage. If you are not using the Slide Panels for any reason, this
pitch to the rear must be maintained!
Place unit on floor, a bench or a table. There is a
Left and Right Window Filler Panel - be sure to use the
proper panel for each side. Once panel is installed, the
flange for securing the panel in place to the window sill will be
facing into the room.
A. Hold the Accordion Panel in one hand and gently pull back the
center to free the open end.
See Figure3.
B. Slide the free end of the panel into the cabinet as shown in
Figures 4. Slide the panel down. Be sure to leave enough space to
slip the top and bottom of the frame into the rails on the cabinet.
C. Once the panel has been installed on the side of the cabinet,
make sure it sits securely inside the frame channel by making
slight adjustments. Slide the top and bottom ends of the frame into
the top and bottom rails of the cabinet.
Figure 5.
D. Slide the panel all the way in and repeat on the other side.
To Next Page
Loading...
