14
Manual Supplement
00809-0400-2410, Rev AA
Rosemount 2410 Tank Hub
March 2016
Rosemount 2410 Tank Hub
1.4 Configuration using the EBM
The Rosemount 2410 Tank Hub is configured by using the Rosemount TankMaster
WinSetup configuration program
(1)
. WinSetup is a user-friendly software package that
includes basic configuration options as well as advanced configuration and service
functions.
Configuration of a tank hub equipped with one communication board (Enraf GPU) must be
performed using an EBM with the normal Modbus protocol. To configure the tank hub for
Enraf emulation, do the following:
1.4.1 Set up Modbus communication protocol
This section describes how to configure the Modbus Master protocol channel for
communication with the EBM. Specify PC communication port and the standard
communication parameters: Baud rate, Parity, and number of Stop Bits.
1. Open the Protocols folder in the Workspace window.
2. Select the Modbus Master icon.
3. Right click the proper MbMaster icon and select Properties to configure the
protocol channel.
1. See the Rosemount Tank Gauging System Configuration Manual (document number 00809-0300-5100) for more information on how
to use the TankMaster WinSetup software to configure the Rosemount 2410 Tank Hub.
To Next Page
Loading...
