26
Reference Manual
00809-0100-4825, Rev CB
Section 3: Configuration
March 2014
Configuration
3.4.1 HART traditional menu tree
Options listed in bold type indicate a selection provides other options. For ease of operation,
changing calibration and setup, such as sensor type, number of wires, and range values, can be
completed from several locations
The review menu lists all of the information stored in the Rosemount 248. This includes device information, measuring element, output
configuration, and software revision
1. Test device
2. Calibration
3. Write protect
On-line Menu
1. Snsr 1 digital reading
2. Terminal digital reading
1. Snsr 1 input trim
2. Snsr 1 trim-fact
3. Active calibrator
1. Loop test
2. Self test
3. Master reset
4. Status
1. SNSR 1 trim
2. D/A trim
3. Scaled D/A trim
1. Revision #s
2. Sensor review
3. Dev outputs review
4. Device information
5. Measurement filtering
1. Process
variables
2. Diagnostics and
service
3. Configuration
4. Review
1. Variable mapping
2. Sensor
configuration
3. Device output
configuration
4. Device
information
5. Measurement
filtering
1. Transmitter vars
2. PV is
3. Snsr 1
4. AO
5. % rnge
6. PV LRV
7. PV URV
8. PV LSL
9. PV USL
10.PV Damping
1. Device setup
2. PV is
3. PV
4. PV AO
5. % RNGE
6. PV LRV
7. PV URV
1. PV is
2. SV is
3. Variable re-map
1. Sensor 1
2. Terminal temp
1. Connections
2. Snsr 1 setup
3. Sensor S/N
1. Terminal units
2. Terminal damp
3. Terminal LSL
4. Terminal USL
1. PV range values
2. Alarm/saturation
3. HART output
1. AO alarm type
2. Low alarm
3. High alarm
4. Low sat.
5. High sat.
1. Poll addr
2. Num req preams
3. Burst mode
4. Burst option
1. Tag
2. Date
3. Descriptor
4. Message
5. Final assembly number
1. 50/60 Hz filter
2. Active calibrator
3. Open sensor holdoff
4. Intermit detect
5. Intermit thresh
1. 2-wire offset
2. Snsr 1 units
3. Snsr 1 damp
4. Snsr LSL
5. Snsr USL
1. PV LRV
2. PV URV
3. PV damping
4. PV units
5. Apply values
6. PV LSL
7. PV USL
8. Min. span
These
numbers are
to be entered
by the user.
To Next Page
Loading...
