Emerson Rosemount 5400 Series - Confirm System Readiness (4-20 Ma Only)

Quick Start Guide
3
June 2016
2.0 Confirm system readiness (4-20 mA only)
2.1 Confirm HART revision capability
This transmitter can be configured for either HART Revision 5 or 7. If using
HART-based control and asset management systems, confirm the HART
capability of those systems prior to transmitter installation. Not all systems are
capable of communicating with the HART Revision 7 protocol.
2.2 Confirm correct Device Driver
 Verify the latest Device Driver (DD/DTM
™
) is loaded on your systems to ensure
proper communication. See Table 1.
 Download the latest Device Driver from www.rosemount.com/LevelSoftware
2.3 Switch HART revision mode
If the HART configuration tool is not capable of communicating with HART
Revision 7, the device will load a generic menu with limited capability.
To switch the HART revision mode from the generic menu:
1. Go to Manual Setup > Device Information > Identification > Message.
2. In the Message field, enter “HART5” or “HART7”.
Table 1. Rosemount 5400 Device Revisions and Files
Firmware version
(1)
1. Firmware version is printed on the transmitter head label, e.g. SW 2C.0.
Find Device Driver
HART universal revision Device revision
(2)
2. Device revision is printed on the transmitter head label, e.g. HART Dev Rev 3.
2A0 and later
73
52
1C0 - 1D0 5 2