Emerson Rosemount 5400 Series - Safety Instrumented Systems (4-20 Ma Only); Product Certifications

Quick Start Guide
21
June 2016
6.0 Safety Instrumented Systems (4-20 mA only)
For Safety Certified installations, refer to the Rosemount 5400 Series Reference
Manual.
7.0 Product Certifications
Rev 3.0
7.1 European Directive Information
A copy of the EU Declaration of Conformity can be found at the end of the Quick Start Guide.
The most recent revision of the EU Declaration of Conformity can be found at
EmersonProcess.com/Rosemount
.
7.2 Ordinary Location Certification
As standard, the transmitter has been examined and tested to determine that the design
meets the basic electrical, mechanical, and fire protection requirements by a nationally
recognized test laboratory (NRTL) as accredited by the Federal Occupational Safety and
Health Administration (OSHA).
7.3 Telecommunication compliance
FCC
This device complies with Part 15C of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Certificate: K8C5401 for Model 5401
K8C5402 for Model 5402
IC
This device complies with RSS210-5.
This device complies with Industry-Canada license-exempt RSS standard. Operation is
subject to the following two conditions: (1) This device may not cause interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Certificate: 2827A-5401
2827A-5402
R&TTE
This device complies with ETSI EN 302 372 and EN 62479. EU directive 99/5/EC.
7.4 Installing Equipment in North America
The US National Electrical Code (NEC
®
) and the Canadian Electrical Code (CEC) permit the
use of Division marked equipment in Zones and Zone marked equipment in Divisions. The
markings must be suitable for the area classification, gas, and temperature class. This
information is clearly defined in the respective codes.