Quick Start Guide
33
March 2016
7.2 Calibration number
The sensor calibration number is a 16-digit number generated at the Rosemount
factory during flow calibration and is unique to each sensor and is located in the
sensor tag.
Table 13. Handheld Fast Keys (Field Communicator)
7.3 Field mount transmitter local operator interface
To activate the optional Local Operator Interface (LOI), press the DOWN arrow
two times. Use the UP, DOWN, LEFT, and RIGHT arrows to navigate the menu
structure. A map of the LOI menu structure is shown on Figure 34. The display can
be locked to prevent unintentional configuration changes. The display lock can
be activated through a HART communication device, or by holding the UP arrow
for three seconds and then following the on-screen instructions. When the
display lock is activated, a lock symbol will appear in the lower right hand corner
of the display. To deactivate the display lock, hold the UP arrow for three seconds
and follow the on-screen instructions. Once deactivated, the lock symbol will no
longer appear in the lower right hand corner of the display.
Function HART fast keys
Process variables 1, 1
Primary Variable (PV) 1, 1, 1
PV Percent of range (PV % rnge) 1, 1, 2
PV Analog Output (AO) (PV Loop current) 1, 1, 3
Totalizer set-up 1, 1, 4
Totalizer units 1, 1, 4, 1
Gross total 1, 1, 4, 2
Net total 1, 1, 4, 3
Reverse total 1, 1, 4, 4
Start totalizer 1, 1, 4, 5
Stop totalizer 1, 1, 4, 6
Reset totalizer 1, 1, 4, 7
Pulse output 1, 1, 5
Basic setup 1, 3
Tag 1, 3, 1
Flow units 1, 3, 2
PV units 1, 3, 2, 1
Special units 1, 3, 2, 2
Line size 1, 3, 3
PV Upper Range Value (URV) 1, 3, 4
PV Lower Range Value (LRV) 1, 3, 5
Calibration number 1, 3, 6
PV Damping 1, 3, 7
Review 1, 5
To Next Page
Loading...
