ER5000 —
8
Safety, Installation & Operations Precautions
INSTALLATION
WARNING
Investigate and apply the most recent standards for Hazardous Locations for
your area set by ANSI, ISO and OSHA, as well as all electrical codes and fire and
safety standards, to determine if your application will require a Hazardous
Location model.
CAUTION
Do not open packaging until ready for installation or in a clean environment. Product
is cleaned in accordance with CGA 4.1 and ASTM G93, Verification Type 1, Test 1 and
Test 2. With periodic verification of cleaning process to MIL-STD-1330D.
WARNING
Make sure that the components and materials used in the fluid handling
system are compatible with the fluid and have the proper pressure rating.
Failure to do so can result in death, serious injury and/or property damage.
Inspect the regulator, valve and accessories for physical damage and contamination.
Do not connect the regulator, valve or accessory if you detect oil, grease or damaged
parts. If the regulator, valve or accessory is damaged, contact your local TESCOM™
representative to have the regulator cleaned or repaired.
REPAIR SERVICE
If a regulator or valve leaks or malfunctions, take it out of service immediately.
You must have instructions before doing any maintenance. Do not make any
repairs you do not understand. Have qualied personnel make repairs. Return any
equipment in need of service to your equipment supplier for evaluation and prompt
service. Equipment is restored to the original factory performance specications,
if repairable. There are at fee repair charges for each standard model. The original
equipment warranty applies after a complete overhaul.
CAUTION
PROPER COMPONENT SELECTION
1. Consider the total system design when selecting a component for use in
a system.
2. The user is responsible for assuring all safety and warning requirements of the
application are met through his/her own analysis and testing.
3. TESCOM may suggest material for use with specic media upon request.
Suggestions are based on technical compatibility resources through
associations and manufacturers. TESCOM does NOT guarantee materials to be
compatible with specic media -- THIS IS THE RESPONSIBILITY OF THE USER!
4. Component function, adequate ratings, proper installation, operation and
maintenance are the responsibilities of the system user.
WARNING
Do not modify equipment or add attachments not approved by the
manufacturer. Failure to do so can result in death, serious injury and/or
property damage.
To Next Page
Loading...
Need help?
General
