36 Unidrive M100-101 Quick Start Guide
Issue Number: 6
Spin Start Boost (00.069) is used by the algorithm that detects the frequency of a spinning motor
when the drive is enabled and Catch A Spinning Motor (00.033) ≥ 1. For smaller motors the default
value of 1.0 is suitable, but for larger motors Spin Start Boost (00.069) may need to be increased.
Defines the action of the drive on detection of a trip.
Bit 0: Stop on defined non-important trips
Bit 1: Disable braking resistor overload detection
Bit 2: Disable phase loss stop
Bit 3: Disable braking resistor temperature monitoring
Bit 4: Disable parameter freeze on trip. Refer to Drive User Guide.
Displays the maximum heavy duty current rating of the drive.
Displays the software version in the drive.
The user drive mode is open-loop only.
00.069 {05.040} Spin Start Boost
RW Num US
OL
Ú
0.0 to 10.0
Ö
1.0
00.076 {10.037} Action On Trip Detection
RW Num ND NC PT US
OL
Ú
0 - 31
Ö
0
00.077 {11.032} Maximum Heavy Duty Rating
RO Num ND NC PT
OL
Ú
0.00 to 9999.99 A
Ö
00.078 {11.029} Software Version
RO Num ND NC PT
OL
Ú
0 to 999999
Ö
00.079 {11.031} User Drive Mode
RW Txt ND NC PT US
OL
Ú
OPEn.LP (1)
Ö
OPEn.LP (1)
Unidrive M100 101 Quick Start Guide English Iss6.book Page 36 Wednesday, September 9, 2015 4:07 PM
To Next Page
Loading...
