Emerson Unidrive M201 - Page 114

114 SI-Ethernet User Guide
Issue: 1
6.1.10 Menu 23– EtherNet/IP Fault Values
This menu contains the parameters used to define the values to be sent to the mapped
output destinations when fault values have been configured to be sent after either a RPI
timeout event (see RPI timeout action (S.20.011), RPI timeout event destination
(S.20.012) and RPI timeout event type (S.20.013)) or a PLC idle event (see PLC idle
action (S.20.015), PLC idle event destination (S.20.016) and PLC idle event type
(S.20.017)) has occurred.
S.23.001 Output Fault value 1
Minimum -2147483648 Maximum 2147483647
Default 0 Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, PT
S.23.002 Output Fault value 2
Minimum -2147483648 Maximum 2147483647
Default 0 Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, PT
S.23.003 Output Fault value 3
Minimum -2147483648 Maximum 2147483647
Default 0 Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, PT
S.23.004 Output Fault value 4
Minimum -2147483648 Maximum 2147483647
Default 0 Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RW, PT